配置Device A为主
配置优先级
sys
irf member 1 priority 32
选定IRF物理端口并关闭这些端口
interface FortyGigE 1/0/53
shutdown
interface FortyGigE 1/0/54
shutdown
配置IRF端口1/2,并将它与物理端口绑定
irf-port 1/2
port group interface FortyGigE 1/0/53
port group interface FortyGigE 1/0/54
开启端口并保存配置
interface FortyGigE 1/0/53
undo shutdown
interface FortyGigE 1/0/54
undo shutdown
save fo
激活IRF端口下的配置
irf-port-configuration active
配置Device B为备
配置优先级
irf member 1 priority 1
将Device B的成员编号配置为2,并重启设备使新编号生效
irf member 1 renumber 2
reboot
y
关闭选定的所有IRF物理端口
interface FortyGigE 2/0/53
shutdown
interface FortyGigE 2/0/54
shutdown
配置IRF端口2/1,并将它与物理端口绑定
irf-port 2/1
port group interface FortyGigE 2/0/53
port group interface FortyGigE 2/0/54
开启端口并保存配置
interface FortyGigE 2/0/53
undo shutdown
interface FortyGigE 2/0/54
undo shutdown
save fo
激活IRF端口下的配置
irf-port-configuration active
Device B间将会进行重启,重启完成后,IRF形成
堆叠BFD MAD检测(单根线)
VLAN 4094
interface ten 1/0/48
undo stp enable
description IRF-BFD
port access vlan 4094
quit
interface ten 2/0/48
undo stp enable
description IRF-BFD
port access vlan 4094
quit
interface Vlan-interface4094
description IRF-BFD
mad bfd enable
mad ip address 1.1.1.1 255.255.255.252 member 1
mad ip address 1.1.1.2 255.255.255.252 member 2
quit
save fo
堆叠BFD MAD检测(冗余线)
注:也可以不启用链路聚合组
vlan 4094
description For:mad
quit
interface Bridge-Aggregation1023
description For:mad
quit
interface Bridge-Aggregation1024
description For:mad
quit
interface Ten-GigabitEthernet1/0/47
undo stp enable
port link-aggregation group 1023
quit
interface Ten-GigabitEthernet1/0/48
undo stp enable
port link-aggregation group 1023
quit
interface Ten-GigabitEthernet2/0/47
undo stp enable
port link-aggregation group 1024
quit
interface Ten-GigabitEthernet2/0/48
undo stp enable
port link-aggregation group 1024
quit
interface Vlan-interface4094
description For:mad
mad bfd enable
mad ip address 169.255.255.1 255.255.255.252 member 1
mad ip address 169.255.255.2 255.255.255.252 member 2
quit
save fo
堆叠BFD MAD检测(三层口)
interface Route-Aggregation1024
description For:mad
quit
nterface Ten-GigabitEthernet1/0/47
port-link mode route
port link-aggregation group 1024
quit
interface Ten-GigabitEthernet1/0/48
port-link mode route
port link-aggregation group 1024
quit
interface Ten-GigabitEthernet2/0/47
port-link mode route
port link-aggregation group 1024
quit
interface Ten-GigabitEthernet2/0/48
port-link mode route
port link-aggregation group 1024
quit
interface Route-Aggregation1024
mad bfd enable
mad ip address 169.255.255.1 255.255.255.252 member 1
mad ip address 169.255.255.2 255.255.255.252 member 2
quit
save fo
LACP MAD检测
需要中间设备Device C,支持LACP协议,才可以采用LACP MAD检测。
Device A与Device B组成IRF系统后,与Device C起LACP链路聚合;
IRF堆叠系统:
interface Bridge-Aggregation1
link-aggregation mode dynamic
mad enable
quit
interface range Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet 2/0/1
port link-aggregation group 1
quit
save fo
Device C中间设备
interface Bridge-Aggregation11
link-aggregation mode dynamic
quit
interface range Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet 1/0/2
port link-aggregation group 11
quit
save fo
请立即点击咨询我们或拨打咨询热线: 17804441181,我们会详细为你一一解答你心中的疑难。项目经理在线