Cisco思科交换机使用第三方模块光模块报错%PM-4-ERR_DISABLE：gbic-invalid error detected on Gi1/0/25，putting Gi1/0/25 in err-disable state

如果使用非cisco模块插入cisco交换机，会提示

%PM-4-ERR_DISABLE：gbic-invalid error detected on Gi1/0/25，putting Gi1/0/25 in err-disable state

Cisco思科 SFP安全密钥机制SFP安全密钥机制通过防止非Cisco SFP的使用来保证质量和兼容性。每个SFP都使用非凡的软件密钥进行编码，交换机在运行时对密钥进行验证，若SFP不包含合法的密钥，那么相应的端口关闭，在没有插入Cisco提供的合法的SFP之前，该端口将不能发送或接收任何数据包。

可以通过隐藏命令，无法从？来找到。

service unsupported-transceiver

no errdisable detect cause gbic-invalid

speed nonegotiate

copy running-config startup-config

然后需对交换机重启后才能生效。

Cisco公司特别说明：用（config）#service unsupported-transceiver指令之后，设备会跳出以下的警告讯息。 

　　Warning： When Cisco determines that a fault or defect can be traced to the use of third-party transceivers installed by a customer or reseller， then，at Ciscos discretion，Cisco may withhold support under warranty or a Cisco support program. In the course of providing support for a Cisco networking product Cisco may require that the end user install Cisco transceivers if Cisco determines that removing third-party parts will assist Cisco in diagnosing the cause of a support issue.